2007-2013 Highlander Kluger · Service Manual BODY

REMOVAL

Removal / installation · Vehicles built May 2007 – Jun 2010

Versions by build date: May 2007 – Jun 2010 from Jul 2010


1. REMOVE REAR QUARTER PANEL MUDGUARD LH (w/ Rear Fender Mudguard)

  1. B172720E01
    Remove the screw (A).

  1. Using a 4 mm hexagon wrench, remove the 6 screws (B).


2. REMOVE REAR QUARTER PANEL MUDGUARD RH (w/ Rear Fender Mudguard)

HINT:
Use the same procedures for the RH side and LH side.


3. REMOVE REAR BUMPER ASSEMBLY (w/ Rear Fender Mudguard)

  1. B172734E01
    Put protective tape around the rear bumper assembly.

  1. B180435
    Remove the 5 clips, 6 screws and 2 bolts.

  1. B172733
    Disengage the 8 claws and disconnect the rear bumper assembly.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Remove the rear bumper assembly.


4. REMOVE REAR BUMPER ASSEMBLY (w/ Rear Fog Light)

  1. B172737E01
    Put protective tape around the rear bumper assembly.

  1. B172735
    Remove the 5 clips, 8 screws and 2 bolts.

  1. B172736
    Disengage the 8 claws and disconnect the rear bumper assembly.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Disconnect the rear fog light connector, and then remove the rear bumper assembly.

← COMPONENTS (from Jul 2010)REMOVAL (from Jul 2010) →