2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

INSTALLATION

Removal / installation · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


1. INSTALL TURN SIGNAL FLASHER ASSEMBLY (for LHD)
  1. Connect the connector.

  1. E151586
    Engage the claw and install the turn signal flasher assembly.


2. INSTALL TURN SIGNAL FLASHER ASSEMBLY (for RHD)

  1. E150614
    Engage the claw and install the turn signal flasher assembly.

  1. Connect the connector.


3. INSTALL POWER STEERING ECU ASSEMBLY (for LHD)

  1. C166319
    Install the power steering ECU assembly with the 3 nuts.

    Torque:
    14 N*m{ 143 kgf*cm , 10 ft.*lbf }

  1. C167533E01
    Check that the connector lever is at the fully unlocked position before installation.

    NOTICE:
    If the lever has been lifted out of the fully unlocked position, it may cause a faulty connection.

  1. C165548E01
    Connect the 4 connectors to the power steering ECU assembly.

  1. Lightly pull on the connector and check that the connector does not disconnect.


4. CONNECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY (for LHD)

  1. E151587
    Connect the instrument panel junction block assembly with the 3 nuts.

    Torque:
    8.4 N*m{ 86 kgf*cm , 74 in.*lbf }


5. INSTALL INSTRUMENT PANEL SAFETY PAD ASSEMBLY
(Click here)
← INSTALLATION (Aug 2008 – Jun 2010)ON-VEHICLE INSPECTION (from May 2007) →