2007-2013 Highlander Kluger · Service Manual BODY

REMOVAL

Removal / installation · Vehicles built from May 2007


1. REMOVE REAR SEAT HEADREST ASSEMBLY

2. REMOVE REAR SEAT TRACK BRACKET COVER

  1. B173760
    Disengage the 8 claws and remove the 2 rear seat track bracket covers.


3. REMOVE REAR OUTER TRACK BRACKET COVER

  1. B173763
    Disengage the 4 claws and remove the rear outer track bracket cover.


4. REMOVE REAR INNER TRACK BRACKET COVER

  1. B173761
    Disengage the 4 claws and remove the rear inner track bracket cover.


5. REMOVE REAR SEAT LEG SIDE COVER

  1. B173765
    Disengage the 3 claws.

  1. Disengage the clip and remove the rear seat leg side cover.


6. DISCONNECT REAR NO. 1 SEAT LOCK CABLE ASSEMBLY (w/ Remote Folding Function)

  1. Pull down the adjuster's lock piece to release the lock as shown in the illustration.

    B180390E01

  1. B173766E01
    Using a screwdriver wrapped with protective tape, disengage the 2 claws as shown in the illustration.

  1. Lift up the seat track adjusting handle to the uppermost position and hold the handle in this position as shown in the illustration.

    B173768E01

  1. Using a screwdriver wrapped with protective tape, disconnect the rear No. 1 seat lock cable assembly as shown in the illustration.

  1. Using a screwdriver wrapped with protective tape, disconnect the rear seat reclining control cable as shown in the illustration.

    B180392E01

  1. Secure the rear seat reclining control cable with the carpet hole as shown in the illustration.


7. REMOVE REAR NO. 1 SEAT ASSEMBLY

  1. B173774
    Remove the 3 bolts on the rear side of the seat.

  1. B173764
    Remove the 2 bolts on the front side of the seat and the rear No. 1 seat assembly.

    NOTICE:
    Be careful not to damage the vehicle body.

← COMPONENTS (from May 2007)DISASSEMBLY (from May 2007) →