2007-2013 Highlander Kluger · Service Manual SECURITIES

INSPECTION

Inspection · Vehicles built from May 2007


INSPECT SECURITY INDICATOR LIGHT

  1. B154244E06
    Disconnect the D36*1 or D9 *2 ECU connector, with the E13 indicator connector connected.

  1. Apply battery voltage from the wire harness back side between the terminals of the indicator, and check the lighting condition of the security indicator.

    Standard :
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal E13-2 (IND+)
    Battery negative (-) → Terminal E13-5 (E)
    Security indicator comes on

    HINT:
    1. *1: w/ Smart entry and start system
    2. *2: w/o Smart entry and start system

    NOTICE:
    1. If the positive (+) lead and the negative (-) lead are incorrectly connected, the security indicator will not come on.
    2. Voltage of more than 12 V will damage the security indicator.
    3. If the voltage is too low, the security indicator will not come on.

    If the result is not as specified, replace the passenger belt and airbag indicator.

← REMOVAL (from Jul 2010)INSTALLATION (May 2007 – Jul 2008) →