2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

INSTALLATION

Removal / installation · Vehicles built from Jul 2010


1. INSTALL MULTI-MEDIA INTERFACE ECU

2. INSTALL NO. 2 MULTI-MEDIA INTERFACE BRACKET
  1. Install the No. 2 multi-media interface bracket with the 2 screws.


3. INSTALL NO. 1 MULTI-MEDIA INTERFACE BRACKET
  1. Install the No. 1 multi-media interface bracket with the 2 screws.


4. INSTALL MULTI-MEDIA INTERFACE ECU WITH BRACKET
  1. Install the multi-media interface ECU with bracket with the 3 nuts.

  1. Connect each connector.


5. INSTALL RADIO RECEIVER ASSEMBLY WITH BRACKET (w/ Radio Receiver)
  1. Connect each connector.

  1. E150552
    Engage the 4 clips.

  1. E150551
    Install the radio receiver assembly with bracket with the 4 bolts.


6. INSTALL NAVIGATION RECEIVER ASSEMBLY WITH BRACKET (w/ Navigation System)
  1. Connect each connector.

  1. E150545
    Engage the 4 clips.

  1. E150544
    Install the navigation receiver assembly with bracket with the 4 bolts.


7. INSTALL HEATER CONTROL AND ACCESSORY ASSEMBLY (for Manual Air Conditioning System)
  1. Connect the connector.

  1. E150368
    Engage the 4 clips and install the heater control and accessory assembly.


8. INSTALL AIR CONDITIONING CONTROL ASSEMBLY (for Automatic Air Conditioning System)
  1. Connect the connector.

  1. E150367
    Engage the 4 clips and install the air conditioning control assembly.


9. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (w/o Smart Entry and Start System)

  1. B184679E01
    Apply protective tape to the areas shown in the illustration.

  1. Connect each connector.

  1. Engage the 10 claws and 8 clips, and install the center instrument cluster finish panel assembly.

    NOTICE:
    Do not the damage the instrument panel safety pad assembly and lower instrument panel finish panel sub-assembly.


10. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (w/ Smart Entry and Start System)

  1. B184681E01
    Apply protective tape to the areas shown in the illustration.

  1. Connect each connector.

  1. Engage the 10 claws and 8 clips, and install the center instrument cluster finish panel assembly.

    NOTICE:
    Do not the damage the instrument panel safety pad assembly and lower instrument panel finish panel sub-assembly.


11. INSTALL CENTER INSTRUMENT PANEL REGISTER ASSEMBLY

  1. B168369
    Engage the 2 claws and 5 clips, and install the center instrument panel register assembly.


12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Navigation System for HDD)

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

← REMOVAL (from Jul 2010)COMPONENTS (from May 2007) →