2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

INSTALLATION

Removal / installation · Vehicles built Aug 2008 – Jun 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


1. INSTALL FRONT NO. 1 SPEAKER ASSEMBLY

  1. E150556
    Install the front No. 1 speaker assembly with the 4 bolts.

    NOTICE:
    Do not touch the cone part of the speaker.

  1. Connect the connector.


2. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY
  1. Connect the connector.

  1. B172935
    Connect the front door lock remote control cable and front door inside locking cable to the front door inside handle sub-assembly.

  1. Engage the 2 clamps.

  1. B172933
    Engage the front door trim board with the 5 claws on the front door inner glass weatherstrip.

  1. Engage the 9 clips.

  1. B172932E01
    Install the 2 screws <B>.

  1. Install the screw <A> and front door trim board to the front door panel.

    Torque:
    3.5 N*m{ 36 kgf*cm , 31 in.*lbf }


3. INSTALL COURTESY LIGHT ASSEMBLY
  1. Connect the connector.

  1. B172930
    Engage the claw and install the courtesy light assembly.


4. INSTALL ASSIST GRIP COVER

  1. B172925
    Engage the 4 claws and install the assist grip cover.


5. INSTALL FRONT ARMREST UPPER BASE PANEL
  1. Connect the connector.

  1. B172923
    Engage the 7 claws and clip and install the front armrest upper base panel.


6. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG

  1. B172921
    Engage the 3 claws and install the front door inside handle bezel plug.


7. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH

  1. B172931
    Engage the clip and claw, and install the front door lower frame bracket garnish.

← INSTALLATION (May 2007 – Jul 2008)INSTALLATION (from Jul 2010) →