REMOVAL
Removal / installation · Vehicles built from Jul 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
| 1.
REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG
|
 |
- Using a screwdriver with the tip wrapped with protective tape, disengage the 3 claws and remove the rear door inside handle bezel plug.
| 2.
REMOVE REAR DOOR ARMREST UPPER BASE PANEL
|
 |
- Using a screwdriver with the tip wrapped with protective tape, disengage the 6 claws and 2 clips, and remove the rear door armrest upper base panel.
Disconnect the connector.
| 3.
REMOVE DOOR ASSIST GRIP COVER
|
 |
- Using a screwdriver with the tip wrapped with protective tape, disengage the 4 claws and remove the door assist grip cover.
| 4.
REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY
|
 |
- Remove the 3 screws.
- Using a clip remover, disengage the 9 clips.
Disengage the 5 claws and separate the rear door trim board sub-assembly from the rear door inner glass weatherstrip.
- Disengage the 2 clamps.
Disconnect the front door lock remote control cable and rear door inside locking cable.
| 5.
REMOVE REAR SPEAKER ASSEMBLY |
 |
- Disconnect the connector.
Remove the 3 bolts and rear speaker assembly.
- NOTICE:
- Do not touch the cone part of the speaker.