2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation · Vehicles built May 2007 – Jul 2008

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


1. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG

  1. B172920E01
    Using a screwdriver with the tip wrapped with protective tape, disengage the 3 claws and remove the rear door inside handle bezel plug.


2. REMOVE REAR DOOR ARMREST UPPER BASE PANEL

  1. B172987E01
    Using a screwdriver with the tip wrapped with protective tape, disengage the 6 claws and 2 clips, and remove the rear door armrest upper base panel.

  1. Disconnect the connector.


3. REMOVE DOOR ASSIST GRIP COVER

  1. B174184E01
    Using a screwdriver with the tip wrapped with protective tape, disengage the 4 claws and remove the door assist grip cover.


4. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

  1. B173155
    Remove the 3 screws.

  1. B173156
    Using a clip remover, disengage the 9 clips.

  1. Disengage the 5 claws and separate the rear door trim board sub-assembly from the rear door inner glass weatherstrip.

  1. B173157
    Disengage the 2 clamps.

  1. Disconnect the front door lock remote control cable and rear door inside locking cable.


5. REMOVE REAR SPEAKER ASSEMBLY

  1. E150558
    Disconnect the connector.

  1. Remove the 3 bolts and rear speaker assembly.

    NOTICE:
    Do not touch the cone part of the speaker.

← ON-VEHICLE INSPECTION (from Jul 2010)REMOVAL (Aug 2008 – Jun 2010) →