2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

ON-VEHICLE INSPECTION

Inspection · Vehicles built May 2007 – Jun 2010

Versions by build date: May 2007 – Jun 2010 from Jul 2010


INSPECT REAR SPEAKER

HINT:
Remove interior parts so that the rear speaker can be seen.

  1. Check the speaker installation.

    OK:
    The speaker is securely installed.

    If the result is not as specified, reinstall the rear speaker.

  1. Visually check the speaker.

    OK:
    The cone paper of the speaker is not torn.

    If the result is not as specified, replace the rear speaker.

  1. Speaker resistance check

    1. Disconnect the rear speaker connector.

    2. Measure the resistance between the terminals of the speaker.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      Always
      Approximately 4 Ω

      If the result is not as specified, replace the rear speaker.

← COMPONENTS (from May 2007)ON-VEHICLE INSPECTION (from Jul 2010) →