2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

INSTALLATION

Removal / installation · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


1. INSTALL FRONT NO. 2 SPEAKER ASSEMBLY

  1. E150560
    Connect the connector.

  1. Install the front No. 2 speaker assembly with the 2 bolts.


2. INSTALL NO. 1 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY

  1. B168375
    Engage the 2 guides.

  1. Engage the 2 claws and 2 clips, and install the No. 1 instrument panel speaker panel sub-assembly.


3. INSTALL FRONT PILLAR GARNISH

  1. B173226E01
    Remove the protective cover.

  1. B260163E01
    Make sure that the front pillar garnish clip is not damaged.

    NOTICE:
    1. If there is any damage, replace the garnish clip with a new one.
    2. When a garnish clip is being replaced, make sure to install it in the direction shown in the illustration.

  1. Engage the 3 guides.

  1. Turn the end of the front pillar garnish clip 90° with needle-nosed pliers and install it to the front pillar garnish LH.

    HINT:
    Tape the tips of the needle-nosed pliers before use.

  1. B260164
    Engage the 2 clips to install the front pillar garnish LH.


4. CONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP

  1. B173235E01
    Align the alignment mark (blue) on the weatherstrip with the protruding portion on the body indicated by the arrow in the illustration, and install the front door opening trim weatherstrip LH.

    NOTICE:
    After installation, check that the corners fit correctly.

← INSTALLATION (Aug 2008 – Jun 2010)COMPONENTS (from May 2007) →