2007-2013 Highlander Kluger · Service Manual BODY

INSPECTION

Inspection · Vehicles built from May 2007


INSPECT BACK WINDOW LOCK ASSEMBLY

  1. B172579E01
    Check operation of the back window lock assembly.

    1. Move the back window lock assembly to the lock position.

    2. Apply the battery voltage to the window lock motor and check the operation of the window lock motor.

      OK: 
      Measurement Condition
      Specified Condition
      Battery positive (+) → 3
      Battery negative (-) → 4
      Unlock
      If the result is not as specified, replace the back window lock assembly.

  1. B172579E01
    Check operation of the back window courtesy switch.

    1. Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      Lock
      10 kΩ or higher
      1 - 2
      Unlock
      Below 1 Ω

      If the result is not as specified, replace the back window lock assembly.

← REMOVAL (from Jul 2010)INSTALLATION (May 2007 – Jul 2008) →