Using a screwdriver with the tip wrapped with protective tape, disengage the 3 claws and remove the rear door inside handle bezel plug.
14.
REMOVE REAR DOOR ARMREST UPPER BASE PANEL (for Rear Door)
Using a screwdriver with the tip wrapped with protective tape, disengage the 6 claws and 2 clips, and remove the rear door armrest upper base panel.
Disconnect the connector.
15.
REMOVE DOOR ASSIST GRIP COVER (for Rear Door)
Using a screwdriver with the tip wrapped with protective tape, disengage the 4 claws and remove the door assist grip cover.
16.
REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY (for Rear Door)
Remove the 3 screws.
Using a clip remover, disengage the 9 clips.
Disengage the 5 claws and separate the rear door trim board sub-assembly from the rear door inner glass weatherstrip.
Disengage the 2 clamps.
Disconnect the front door lock remote control cable and rear door inside locking cable.
17.
REMOVE REAR DOOR INNER GLASS WEATHERSTRIP
Remove the rear door inner glass weatherstrip from the rear door panel.
18.
REMOVE REAR DOOR SERVICE HOLE COVER (for Rear Door)
Disconnect the connector.
Remove the rear door service hole cover.
HINT:
Remove the remaining tape on the door.
19.
REMOVE REAR DOOR WEATHERSTRIP (for Rear Door)
Remove the upper part of the front door weatherstrip to the extent that allows removal of the rear door window division bar sub-assembly.
20.
REMOVE REAR DOOR GLASS RUN (for Rear Door)
Remove the rear door glass run.
21.
REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY (for Rear Door)
Remove the rear door vent seal.
Remove the 2 bolts, screw, and the rear door window division bar sub-assembly.
22.
REMOVE REAR DOOR QUARTER WINDOW GLASS (for Rear Door)
Remove the rear door quarter window glass and the rear door quarter window weatherstrip as a unit as shown in the illustration.
Remove the rear door quarter window glass from the rear door quarter window weatherstrip.
23.
REMOVE REAR DOOR GLASS SUB-ASSEMBLY (for Rear Door)
Remove the rear door glass sub-assembly from the rear door window regulator sub-assembly as shown in the illustration.
NOTICE:
Do not damage the door glass.
24.
REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY (for Rear Door)
Disconnect the connector.
Loosen the temporary bolt.
NOTICE:
Do not remove the temporary bolt. If the temporary bolt is removed, the rear door window regulator may fall and cause damage.
Remove the 3 bolts.
Remove the rear door window regulator sub-assembly and the rear power window regulator motor assembly as a unit.
Remove the temporary bolt from the rear door window regulator sub-assembly.
25.
REMOVE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Rear Door)
Connect the positive (+) lead of the battery to terminal 2, and the negative (-) lead to terminal 1 of the rear power window regulator motor assembly to move the lift arm to the position shown in the illustration.
Using a "TORX" driver (T25), remove the 3 screws and the rear power window regulator motor assembly.