2007-2013 Highlander Kluger · Service Manual BRAKE

C1419 Acceleration Sensor Internal Circuit

Diagnostic trouble codes · Vehicles built from Jul 2010

Also covers:

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

The skid control ECU receives signals from the yaw rate and acceleration sensor via the CAN communication system.
The yaw rate sensor has a built-in acceleration sensor and detects the vehicle's condition using 2 circuits (GL1, GL2).
If there is trouble in the bus lines between the yaw rate and acceleration sensor and the CAN communication system, DTCs U0123 (malfunction in CAN communication with the yaw rate sensor) and U0124 (malfunction in CAN communication with the acceleration sensor) are set.
These DTCs are also output when calibration has not been completed.
DTC Code
DTC Detection Condition
Trouble Area
C1419
A data malfunction signal is received from the acceleration sensor.
Yaw rate and acceleration sensor
C1435
A data malfunction signal is received from the yaw rate sensor.
Yaw rate and acceleration sensor

WIRING DIAGRAM

Refer to DTCs C1232, C1243 and C1245 (Click here).

INSPECTION PROCEDURE

NOTICE:
When replacing the yaw rate and acceleration sensor, perform zero point calibration (Click here).

HINT:
When U0123, U0124 and/or U0126 is output together with C1419 and/or C1435, inspect and repair the trouble areas indicated by U0123, U0124 and/or U0126 first (Click here).


1. REPLACE YAW RATE AND ACCELERATION SENSOR
  1. Replace the yaw rate and acceleration sensor (Click here).

    NOTICE:
    Check the yaw rate and acceleration sensor signal after replacement (Click here).

    HINT:
    If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step (Click here).


NEXT

END


← C1419 Acceleration Sensor Internal Circuit (+ C1435) (Aug 2008 – Jun 2010)C1420 Acceleration Sensor Malfunction (May 2007 – Jul 2008) →