C1419 Acceleration Sensor Internal Circuit
Diagnostic trouble codes · Vehicles built May 2007 – Jul 2008
Also covers:
- C1435 Yaw Rate Sensor Internal Circuit
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
DESCRIPTION
The skid control ECU receives signals from the yaw rate and acceleration sensor via the CAN communication system.The yaw rate sensor has a built-in acceleration sensor and detects the vehicle's condition using 2 circuits (GL1, GL2).
If there is trouble in the bus lines between the yaw rate and acceleration sensor and the CAN communication system, DTCs U0123 (malfunction in CAN communication with the yaw rate sensor) and U0124 (malfunction in CAN communication with the acceleration sensor) are set.
These DTCs are also output when calibration has not been completed.
| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1419 |
A data malfunction signal is received from the acceleration sensor. |
Yaw rate and acceleration sensor |
| C1435 |
A data malfunction signal is received from the yaw rate sensor. |
Yaw rate and acceleration sensor |
WIRING DIAGRAM
Refer to DTCs C1232, C1243 and C1245 (Click here).INSPECTION PROCEDURE
- NOTICE:
- When replacing the yaw rate and acceleration sensor, perform zero point calibration (Click here).
- HINT:
- When U0123, U0124 and/or U0126 is output together with C1419 and/or C1435, inspect and repair the trouble areas indicated by U0123, U0124 and/or U0126 first (Click here).
| 1. REPLACE YAW RATE AND ACCELERATION SENSOR |
Replace the yaw rate and acceleration sensor (Click here).
- NOTICE:
- Check the yaw rate and acceleration sensor signal after replacement (Click here).
- HINT:
- If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step (Click here).
| NEXT | ||
| ||
