2007-2013 Highlander Kluger · Service Manual SECURITIES

Security Horn Circuit

Circuit diagnosis · Vehicles built May 2007 – Jul 2008

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

When the theft deterrent system is switched from the armed state to the alarm sounding state, the certification ECU (smart key ECU assembly) controls the security horn.

WIRING DIAGRAM

B154245E03

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - ENGINE ROOM JUNCTION BLOCK)

  1. B178144E03
    Disconnect the D35 ECU connector.

  1. Connect a negative battery lead to terminal 20 (SH-) of the D35 ECU connector.

  1. Check operation of the security horn.

    OK:
    Measurement Condition
    Specified Condition
    Battery negative (-) → D35-20 (SH-)
    Horn sounds



NG
Go to step 2
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

2. INSPECT SECURITY HORN ASSEMBLY

  1. B139440
    Remove the security horn assembly.

  1. Connect a positive battery lead to terminal 1 of the security horn assembly, and a negative battery lead to the horn body.

  1. Check operation of the horn.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 1
    Horn sounds
    Battery negative (-) → Horn body



NG
REPLACE SECURITY HORN ASSEMBLY (Click here)
OK


3. CHECK HARNESS AND CONNECTOR (ENGINE ROOM JUNCTION BLOCK - SECURITY HORN ASSEMBLY)

  1. B154256E02
    Disconnect the 2A engine room junction block connector and A16 security horn assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    2A-5 - A16-1
    Always
    Below 1 Ω
    2A-5 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. CHECK HARNESS AND CONNECTOR (BATTERY - ENGINE ROOM JUNCTION BLOCK)

  1. B178145E02
    Disconnect the 2G engine room junction block connector.

  1. Measure the voltage on the junction block side according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    2G-1 - Body ground
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5. CHECK HARNESS AND CONNECTOR (ENGINE ROOM JUNCTION BLOCK - CERTIFICATION ECU)
  1. Disconnect the 2D engine room junction block connector.

  1. Disconnect the D35 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.B181282E01

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    2D-11 - D35-20 (SH-)
    Always
    Below 1 Ω
    D35-20 (SH-) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ENGINE ROOM JUNCTION BLOCK


← Horn Circuit (from Jul 2010)Security Horn Circuit (Aug 2008 – Jun 2010) →