2007-2013 Highlander Kluger · Service Manual BODY

Jam Protection Function Activates During Power Back Door Operation

Circuit diagnosis · Vehicles built May 2007 – Jul 2008

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

When the jam protection function activates during power back door operation, one of the following may be the cause: 1) improper fit of back door, or a foreign object is stuck in the back door, 2) malfunctioning power back door touch sensor circuit, or 3) malfunctioning power back door ECU.

WIRING DIAGRAM

B165200E05

INSPECTION PROCEDURE


1. CHECK BACK DOOR LOCK FUNCTION
  1. Check if there are any foreign objects interfering with the back door operation.

    OK:
    There are no foreign objects.



NG
REMOVE FOREIGN OBJECT
OK


2. CHECK BACK DOOR
  1. Check the back door operation.

    1. Turn the door control main switch off.

    2. Open / close the back door by hand.

      OK:
      The back door fully opens and closes smoothly.



NG
ADJUST BACK DOOR
OK


3. READ VALUE ON INTELLIGENT TESTER (POWER BACK DOOR TOUCH SENSOR)
  1. Check the Data List to determine if the power back door touch sensor functions properly.

    Back door (Power back door ECU) 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    PBD Touch Sen L
    Power back door touch sensor LH signal / ON or OFF
    ON: Power back door touch sensor LH pressed
    OFF: Power back door touch sensor LH not pressed
    -
    PBD Touch Sen R
    Power back door touch sensor RH signal / ON or OFF
    ON: Power back door touch sensor RH pressed
    OFF: Power back door touch sensor RH not pressed
    -

    OK:
    The power back door sensors function as specified in the normal condition.



NG
GO TO OTHER FLOW CHART (Click here)
OK

REPLACE POWER BACK DOOR DRIVE UNIT (POWER BACK DOOR ECU) (Click here)


← Power Back Door Warning System does not Operate (from Jul 2010)Jam Protection Function Activates During Power Back Door Operation (Aug 2008 – Jun 2010) →