2007-2013 Highlander Kluger · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from May 2007


INSPECT DUTY VACUUM SWITCHING VALVE (OPERATION)

  1. A052014E04
    Check the operation of the duty vacuum switching valve when positive battery voltage is applied to its terminals.

    Positive battery voltage is not applied:
    The air from pipe G is flowing out through pipes E and H.

    Positive battery voltage is applied:
    The air from pipe F is flowing out through pipes E and H.


INSPECT DUTY VACUUM SWITCHING VALVE (RESISTANCE)

  1. A172495E01
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    19 to 21 Ω

    If the resistance is not as specified, replace the duty vacuum switching valve.

← REMOVAL (from Jul 2010)INSTALLATION (May 2007 – Jul 2008) →