2007-2013 Highlander Kluger · Service Manual BRAKE

C1442 Invalid Data Received from Acceleration Sensor

Diagnostic trouble codes · Vehicles built Aug 2008 – Jun 2010

Also covers:

Versions by build date: Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

The skid control ECU receives signals from the yaw rate and acceleration sensor via the CAN communication system.
The yaw rate sensor has a built-in acceleration sensor and detects the vehicle condition.
DTC Code
DTC Detection Condition
Trouble Area
C1442
With terminal IG1 voltage between 9.5 and 17.4 V, an invalid data signal is received from the acceleration sensor for 10 seconds or more.
Yaw rate and acceleration sensor
C1443
With terminal IG1 voltage between 9.5 and 17.4 V, an invalid data signal is received from the yaw rate sensor for 10 seconds or more.
Yaw rate and acceleration sensor

INSPECTION PROCEDURE

NOTICE:
When replacing the yaw rate and acceleration sensor, perform zero point calibration (Click here).


1. CHECK DTC
  1. Clear the DTCs (Click here).

  1. Start and idle the engine for 60 seconds, and then stop the engine.

  1. Check if the same DTC is recorded (Click here).

    Result:
    Result
    Proceed to
    DTCs (C1442 and/or C1443) are output
    A
    DTCs (C1442 and C1443) are not output
    B

    HINT:
    If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step (Click here).



B
CHECK FOR INTERMITTENT PROBLEMS (SYMPTOM SIMULATION) (Click here)
A

REPLACE YAW RATE AND ACCELERATION SENSOR (Click here)


← C1441 Performance Decline of Brake Function (from Aug 2008)C1442 Invalid Data Received from Acceleration Sensor (+ C1443) (from Jul 2010) →