2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

CB-13 USB Over Current Detection

Diagnostic trouble codes · Vehicles built from Jul 2010

DESCRIPTION

DTC No.
DTC Detection Condition
Trouble Area
CB-13
"iPod" or USB device overcurrent malfunction
  1. "iPod" or USB device
  2. No. 1 stereo jack adapter assembly
  3. Harness or connector
  4. Multi-media interface ECU

WIRING DIAGRAM

E213821E03

INSPECTION PROCEDURE


1. REPLACE USB DEVICE OR "iPod"
  1. Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.

  1. Turn the ignition switch off.

    HINT:
    When this DTC has been stored, it is necessary to turn off the ignition switch to make it possible for the vehicle to recognize a new device when it is connected.

  1. Turn the ignition switch to ACC.

  1. Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.


NEXT


2. CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


3. RECHECK FOR DTC
  1. Recheck for DTCs and check if the same DTC is output again.

    HINT:
    If DTCs are detected frequently, replace the multi-media interface ECU.

    OK:
    No DTCs are output.



NG
Go to step 4
OK

USB DEVICE OR "iPod" WAS DEFECTIVE

4. INSPECT MULTI-MEDIA INTERFACE ECU

  1. E210105E08
    Disconnect the No. 1 stereo jack adapter assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    E27-1 (UPI) - E27-4 (UJSG)
    Ignition switch ACC
    5 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to No. 1 Stereo Jack Adapter Assembly)



NG
Go to step 5
OK

REPLACE NO. 1 STEREO JACK ADAPTER ASSEMBLY (Click here)

5. CHECK HARNESS AND CONNECTOR

  1. E210106E04
    Disconnect the multi-media interface ECU connector.

  1. E210105E09
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E28-4 (UPO) - E27-1 (UPI)
    Always
    Below 1 Ω
    E28-1 (UESG) - E27-4 (UJSG)
    Always
    Below 1 Ω
    E27-1 (UPI) - Body ground
    Always
    10 kΩ or higher
    E27-4 (UJSG) - Body ground
    Always
    10 kΩ or higher

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Multi-media Interface ECU)
    *b
    Front view of wire harness connector
    (to No. 1 Stereo Jack Adapter Assembly)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MULTI-MEDIA INTERFACE ECU (Click here)


← CB-10 System Microcomputer Malfunction (+ CB-11, CB-12) (from Jul 2010)CB-43 USB Device Class/Protocol Error (+ CB-44, CB-50, CB-51, CB-7D) (from Jul 2010) →