CB-45 USB Communication Error
Diagnostic trouble codes · Vehicles built from Jul 2010
Also covers:
- CB-46 iPod Control Error
- CB-47 iPod Communication Error
DESCRIPTION
| DTC No. |
DTC Detection Condition |
Trouble Area |
| CB-45 |
Communication error with USB device |
|
| CB-46 |
"iPod" control software malfunction |
|
| CB-47 |
Communication error with "iPod" |
INSPECTION PROCEDURE
- HINT:
- After the inspection is completed, clear the DTCs.
| 1. CHECK CONNECTION METHOD |
Check the method used to connect the USB device or "iPod" to the No. 1 stereo jack adapter assembly.
- Result:
Condition
Proceed to
USB device or "iPod" is connected using a connection cable.
A
USB device is directly connected.
B
|
|
||||
| A | |
| 2. REPLACE CONNECTION CABLE |
Disconnect the USB device or "iPod" and connection cable from the No. 1 stereo jack adapter assembly.
Turn the ignition switch off.
- HINT:
- When one of these DTCs has been stored, it is necessary to turn off the ignition switch to make it possible for the vehicle to recognize a new device when it is connected.
Turn the ignition switch to ACC.
Connect a known good connection cable to the No. 1 stereo jack adapter assembly and connect the USB device or "iPod" to the connection cable.
| NEXT | |
| 3. CLEAR DTC |
Clear the DTCs (Click here).
| NEXT | |
| 4. CHECK DTC |
Recheck for DTCs and check if the same DTC is output again.
- HINT:
- If DTCs are detected frequently, replace the multi-media interface ECU.
- OK:
- No DTCs are output.
|
|
||||
| OK | ||
| ||
| 5. REPLACE USB DEVICE OR "iPod" |
Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.
Turn the ignition switch off.
- HINT:
- When one of these DTCs has been stored, it is necessary to turn off the ignition switch to make it possible for the vehicle to recognize a new device when it is connected.
Turn the ignition switch to ACC.
Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.
- HINT:
- If the malfunction occurred when a USB device was in use, use another USB device for the inspection. If the malfunction occurred when an "iPod" was in use, use another "iPod" for the inspection.
| NEXT | |
| 6. CLEAR DTC |
Clear the DTCs (Click here).
| NEXT | |
| 7. RECHECK FOR DTC |
Recheck for DTCs and check if the same DTC is output again.
- HINT:
- If DTCs are detected frequently, replace the multi-media interface ECU.
- OK:
- No DTCs are output.
|
|
||||
| OK | ||
| ||
