2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

Multi-media Interface ECU Power Source Circuit

Circuit diagnosis · Vehicles built from Jul 2010

DESCRIPTION

This circuit provides power to the multi-media interface ECU.

WIRING DIAGRAM

E180194E69

INSPECTION PROCEDURE


1. INSPECT MULTI-MEDIA INTERFACE ECU

  1. E182617E56
    Disconnect the multi-media interface ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    E25-12 (+B) - E25-7 (GND)
    Always
    11 to 14 V
    E25-11 (ACC) - E25-7 (GND)
    Ignition switch ACC
    11 to 14 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Multi-media Interface ECU)



NG
Go to step 2
OK

REPLACE MULTI-MEDIA INTERFACE ECU (Click here)

2. CHECK HARNESS AND CONNECTOR
  1. Disconnect the radio receiver connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E25-11 (ACC) - E24-11 (ACC)
    Always
    Below 1 Ω
    E25-12 (+B) - E24-12 (+B)
    Always
    Below 1 Ω
    E25-7 (GND) - E24-7 (GND)
    Always
    Below 1 Ω
    E25-11 (ACC) - Body ground
    Always
    10 kΩ or higher
    E25-12 (+B) - Body ground
    Always
    10 kΩ or higher
    E25-7 (GND) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Radio Receiver Power Source Circuit (from Jul 2010)PRECAUTION (May 2007 – Jul 2008) →