2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

INSPECTION

Inspection · Vehicles built from Jul 2010


INSPECT HEADLIGHT LEVELING SWITCH

  1. E133257E06
    Connect a (+) lead from the battery to terminal 1 and a (-) lead to terminal 4.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Position
    Specified Condition
    (Battery voltage is 12 V)
    2 - 1
    0
    10.44 to 11.16 V
    (0.5)
    9.8 to 10.52 V
    1
    9.16 to 9.88 V
    (1.5)
    8.52 to 9.24 V
    2
    7.88 to 8.6 V
    (2.5)
    7.3 to 7.97 V
    3
    6.6 to 7.32 V
    (3.5)
    5.97 to 6.68 V
    4
    5.32 to 6.04 V
    (4.5)
    4.68 to 5.4 V
    5
    4.04 to 4.76 V

    If the result is not as specified, replace the switch.

  1. Connect a (+) lead from the battery to terminal 3 and a (-) lead to terminal 4.

  1. Check that the illumination of the switch comes on.

    OK:
    The illumination comes on.

    Text in Illustration 
    *1
    Component without harness connected
    (Headlight Leveling Switch)
    If the result is not as specified, replace the switch.

← REMOVAL (from Jul 2010)INSTALLATION (from Jul 2010) →