2007-2013 Highlander Kluger · Service Manual BODY

REASSEMBLY

Removal / installation · Vehicles built from Jul 2010


1. INSTALL OUTER MIRROR COVER

  1. B173461
    Engage the 8 claws to install the outer mirror cover to the outer rear view mirror assembly with cover.

    NOTICE:
    If there is a gap between the cover and the mirror body, it may cause noise during driving.


2. INSTALL LENS COVER
  1. Pass the wire harness through the outer mirror holder.

  1. B262177
    Install the lens cover as shown in the illustration.

  1. Engage the 2 guides.

  1. Install the lens cover with the 2 screws.


3. INSTALL OUTER MIRROR GLASS (w/o Heater)

  1. B173448
    Engage the 2 claws on the upper part of the outer mirror glass to the outer mirror.

  1. B173449
    Engage the 2 claws on the lower part of the outer mirror glass to the outer mirror as shown in the illustration.


4. INSTALL OUTER MIRROR GLASS (w/ Heater)

  1. B173447
    Connect the connectors.

  1. B173448
    Engage the 2 claws on the upper part of the outer mirror glass to the outer mirror.

  1. B173449
    Engage the 2 claws on the lower part of the outer mirror glass to the outer mirror as shown in the illustration.

← INSPECTION (from Jul 2010)INSTALLATION (May 2007 – Jul 2008) →