2007-2013 Highlander Kluger · Service Manual BODY

DISASSEMBLY

Removal / installation · Vehicles built from Jul 2010


1. REMOVE BACK DOOR UPPER ROD

  1. B327983
    Clamp the back door motor unit in a vise between aluminum plates.

  1. Remove the nut and power back door arm sub-assembly.

    NOTICE:
    Make sure to replace the back door upper rod with a new one.


2. REMOVE BACK DOOR CLOSER NO. 1 GEAR

  1. B328001
    Remove the 3 screws.

    NOTICE:
    Make sure to replace the 3 screws with new ones.

  1. B328002
    Remove the 2 bolts and power back door bracket sub-assembly.

    NOTICE:
    Make sure to replace the 2 bolts with new ones.

  1. B328003
    Remove the bolt and power back door case sub-assembly.

    NOTICE:
    Make sure to replace the bolt with a new one.

  1. B327995
    Remove the power back door wave washer as shown in the illustration.

  1. B327993
    Remove the power back door No. 4 gear as shown in the illustration.

  1. B327991
    Remove the power back door gear sub-assembly as shown in the illustration.

    NOTICE:
    Make sure to replace the power back door gear sub-assembly with new one.

  1. B327987
    Remove the power back door No. 3 shaft as shown in the illustration.

  1. B327990
    Remove the bolt and power back door bracket sub-assembly.

    NOTICE:
    Make sure to replace the bolt with a new one.

  1. B327989
    Remove the 3 screws and power back door case sub-assembly.

    NOTICE:
    Make sure to replace the 3 screws and power back door case sub-assembly with new ones.

← REMOVAL (from Jul 2010)REASSEMBLY (from Jul 2010) →