2007-2013 Highlander Kluger · Service Manual BODY

REASSEMBLY

Removal / installation · Vehicles built from Jul 2010


1. INSTALL BACK DOOR CLOSER NO. 1 GEAR

  1. B327989
    Install a new power back door case sub-assembly with 3 new screws.

    Torque:
    2.0 N*m{ 20 kgf*cm , 18 in.*lbf }

  1. B332327
    Apply power back door grease to the sliding parts of the power back door case sub-assembly.

  1. B327988
    Install the power back door No. 3 shaft as shown in the illustration.

    NOTICE:
    Make sure not to apply power back door grease to the threads of the power back door No. 3 shaft to avoid the nut of the power back door arm sub-assembly from becoming loose.

  1. B332323
    Install a mew new power back door gear sub-assembly as shown in the illustration.

    NOTICE:
    Make sure not to apply power back door grease to the threads of the power back door No. 3 shaft to avoid the nut of the power back door arm sub-assembly from becoming loose.

  1. B332329
    Apply power back door grease to the sliding parts of the new power back door gear sub-assembly.

  1. B332324
    Install the power back door No. 4 gear as shown in the illustration.

    NOTICE:
    Make sure not to apply power back door grease to the threads of the power back door No. 3 shaft to avoid the nut of the power back door arm sub-assembly from becoming loose.

  1. B332328
    Apply power back door grease to the sliding parts of the power back door No. 4 gear.

  1. B332325
    Install the power back door wave washer as shown in the illustration.

    NOTICE:
    Make sure not to apply power back door grease to the threads of the power back door No. 3 shaft to avoid the nut of the power back door arm sub-assembly from becoming loose.

  1. B332326
    Install the power back door bracket sub-assembly with 2 new bolts.

    Torque:
    13 N*m{ 127 kgf*cm , 9 ft.*lbf }

  1. B328002
    Install the power back door bracket sub-assembly with 2 new bolts.

    Torque:
    13 N*m{ 127 kgf*cm , 9 ft.*lbf }

  1. B328001
    Install power back door case sub-assembly with 3 new screws.

    Torque:
    2.0 N*m{ 20 kgf*cm , 18 in.*lbf }


2. INSTALL BACK DOOR UPPER ROD

  1. B327983
    Clamp a new power back door arm sub-assembly in a vise between aluminum plates.

    Torque:
    74 N*m{ 754 kgf*cm , 55 ft.*lbf }

  1. Install the power back door arm sub-assembly with a new nut.

  1. B327984
    Attach the ball joint to install a new power back door rod.

← DISASSEMBLY (from Jul 2010)INSTALLATION (May 2007 – Jul 2008) →