Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Screen Flicker or Color Distortion

for Preparation Click here


INSPECTION PROCEDURE

1.CHECK DISPLAY SETTING


    E120095
  1. Enter the display adjustment screen by pressing the "DISP" switch.

  1. Reset display settings (contrast, brightness) and check that the screen appears normal.



    E120096E04
  1. Press the "INFO" switch and then select "Screen Setting."



    E120097
  1. Set "Switch Color" to "Green" (initial setting) and check if the display returns to normal.

    OK:
    The display returns to normal.



NG
Go to step 2
OK

END 

2.CHECK CABIN
  1. Check that the cabin temperature is higher than -20°C (-4.0°F).

    OK:
    The cabin temperature is higher than -20°C (-4.0°F).



NG
HEAT CABIN AND RECHECK TEMPERATURE
OK


3.CHECK COLOR BAR (DISPLAY CHECK MODE)


    I100037E05
  1. Enter the "Display Check" mode (Color Bar Check) (Click here).

  1. Check that the color bars match the displayed names.

    OK:
    Color bars match the displayed names.



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK


4.CHECK NAVI COLOR BAR (NAVIGATION CHECK MODE)
I100050E04
  1. Enter the "Navigation Check" mode (NAVI Color Bar Check) (Click here).

  1. Check that the color bars match the displayed names.

    OK:
    Color bars match the displayed names.



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)