Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > DISPLAY CHECK MODE

for Preparation Click here


HINT:
  1. This mode checks the color display on the display.
  2. Illustrations may differ from the actual vehicle screen depending on the device settings and options. Therefore, some detailed areas may not be shown exactly the same as on the actual vehicle screen.


ENTER DIAGNOSTIC MODE (Click here)

DISPLAY CHECK


    E120055E02
  1. Select "Display Check" from the "Diagnosis MENU" screen.


COLOR BAR CHECK


    E120053E36
  1. Select "Color Bar Check" from the "Display Check" screen.



  2. E120102
  3. Select a color bar from the "Color Bar Check Mode" screen.

  4. Check the display color.

    HINT:
    1. The entire screen turns to the color or stripe selected.
    2. Touching the display will return to the "Color Bar Check" screen.


TOUCH SWITCH CHECK


    E125809E06
  1. Select "Touch Switch Check" from the "Display Check" screen.



  2. E120103
  3. Touch the display anywhere in the open area to perform the check when the "Touch Switch Check" screen is displayed.

    HINT:
    1. A "+" mark is displayed where the display is touched.
    2. The "+" mark remains on the display even after the finger is removed.


PANEL SWITCH CHECK


    E125809E07
  1. Select "Panel Switch Check" from the "Display Check" screen.



  2. I100041E07
  3. Operate each switch and check that the switch names and condition are correctly displayed.

    Display
    Contents
    Push switch name/*1
    1. Name of the pressed switch is displayed.
    2. If more than one switch is pressed, "MULTIPLE" will be displayed.
    Rotary switch name/*2
    Name of the rotary switch is displayed.
    Rotary switch direction/*3
    Direction of the rotary switch is displayed.


VEHICLE SIGNAL CHECK


    E125809E08
  1. Select "Vehicle Signal Check" from the "Display Check" screen.



  2. E125810
  3. When the "Vehicle Signal Check Mode" screen is displayed, check all the vehicle signal conditions.

    HINT:
    1. Only conditions having inputs are displayed.
    2. This screen is updated once per second when input signals to the vehicle are changed.
    3. For details of this function, refer to DIAGNOSIS DISPLAY DETAILED DESCRIPTION (Click here).