ENGINE IMMOBILISER SYSTEM (w/ Smart Key System) > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CUSTOMER PROBLEM ANALYSIS CHECK |
| What | Vehicle model, system name |
| When | Date, time, occurrence frequency |
| Where | Road conditions |
| Under what conditions? | Driving conditions, weather conditions |
| How did it happen? | Problem symptoms |
| |||||
| 3.INSPECT BATTERY VOLTAGE |
Measure the battery voltage.
| |||||
| 4.CRANK ENGINE FOR MORE THAN 10 SECONDS |
| |||||
| 5.CHECK FOR DTCS |
Check for DTCs and note any codes that are output (Click here).
Delete the DTCs.
Recheck for DTCs. Based on the DTCs output above, try to duplicate the SFI system DTC, engine immobiliser system DTC, steering lock system DTC, or smart key system (starting) DTC by simulating the symptoms indicated by the DTCs.
| Result | Proceed to |
| SFI system DTC output recurs | A (Click here) |
| Engine immobiliser system DTC output recurs | B (Click here) |
| Steering lock system DTC output recurs | C (Click here) |
| Smart key system (starting) DTC output recurs | D (Click here) |
| DTC output does not recur | E |
|
| ||||
|
| ||||
|
| ||||
|
| ||||
| |||||
| 6.PROBLEM SYMPTOMS TABLE |
| Result | Proceed to |
| Fault is listed in problem symptoms table | A |
| Fault is not listed in problem symptoms table | B |
|
| ||||
| |||||
| 7.OVERALL ANALYSIS AND TROUBLESHOOTING |
DATA LIST/ACTIVE TEST (Click here)
TERMINALS OF ECU (Click here)
| |||||
| 8.ADJUST, REPAIR OR REPLACE |
| |||||
| 9.CONFIRMATION TEST |
|
| ||||
|---|---|---|---|---|---|