Home › ENGINE › 2GR-FE FUEL › FUEL PUMP

FUEL PUMP > DISASSEMBLY

for Preparation Click here



1. REMOVE FUEL SENDER GAUGE ASSEMBLY


    A141357E01
  1. Disconnect the connector and remove the fuel sender gauge from the fuel suction tube.



2. REMOVE FUEL SUCTION PLATE SUB-ASSEMBLY


    A138657E01
  1. Using needle nozzle pliers, remove the E-ring.



    A141315E01
  1. Disengage the 2 claws of the No. 1 fuel suction support and remove the fuel suction plate with the fuel filter from the No. 1 fuel sub-tank.

  1. Remove the spring from the fuel suction plate.



    A141317E01
  1. Disengage the claw of the jet pump nozzle.

  1. Separate the fuel pump filter hose.



3. DISCONNECT FUEL PUMP HARNESS


    A139181E01
  1. Disconnect the fuel pump harness connector.

    NOTICE:
    Do not separate the tube indicated in the illustration (Click here).



4. REMOVE FUEL PUMP


    A105596
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 5 claws on the filter and remove the fuel pump from the fuel filter.

    NOTICE:
    1. Do not damage the fuel filter.
    2. Do not remove the suction filter.
    3. Do not use either the fuel pump or the suction filter if the suction filter is removed from the fuel pump.



    A175690
  1. Disconnect the fuel pump connector.



    A125203E02
  1. Remove the O-ring from the fuel filter.



5. REMOVE FUEL PRESSURE REGULATOR ASSEMBLY


    A124272E02
  1. Remove the fuel pressure regulator from the fuel filter.



    A096585E03
  1. Remove the 2 O-rings from the fuel pressure regulator.



6. REMOVE NO. 1 FUEL SUCTION SUPPORT


    A124271E01
  1. Using a screwdriver with the tip taped, disengage the claw and remove the fuel No. 1 suction support.