Home › ENGINE › 2GR-FE FUEL › FUEL PUMP

FUEL PUMP > REASSEMBLY

for Preparation Click here



1. INSTALL NO. 1 FUEL SUCTION SUPPORT


    A125428E02
  1. Install the No. 1 fuel suction support to the fuel filter.



2. INSTALL FUEL PRESSURE REGULATOR ASSEMBLY


    A097616E09
  1. Apply a light coat of gasoline or spindle oil to 2 new O-rings, then install them onto the fuel pressure regulator.



    A124272E02
  1. Install the fuel pressure regulator to the fuel filter.



3. INSTALL FUEL PUMP


    A091831E02
  1. Apply gasoline to a new O-ring and install it to the fuel filter.



    A124273E01
  1. Engage the 5 claws on the fuel filter and install the fuel pump with the pump filter.



4. CONNECT FUEL PUMP HARNESS


    A124274E01
  1. Connect the fuel pump harness connector.

    NOTICE:
    Do not separate the tube indicated in the illustration (Click here).



5. INSTALL FUEL SUCTION PLATE SUB-ASSEMBLY


    A141316E01
  1. Install the fuel pump filter tube while aligning it to the installation position of the No. 1 fuel sub-tank.

  1. Connect the jet pump nozzle.



    A139157E02
  1. Make sure that the fuel tube passes under the protrusion of the fuel filter, and engage the claw of the No. 1 fuel suction support.

  1. Install the spring to the fuel suction plate shaft and install it to the No. 1 fuel sub-tank.



    A138657E01
  1. Install a new E-ring.



6. INSTALL FUEL SENDER GAUGE ASSEMBLY


    A141357E02
  1. Slide the fuel sender gauge to fit the claw.

  1. Connect the fuel sender gauge connector.