REAR AIRBAG SENSOR > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE REAR DOOR SCUFF PLATE |
![]() |
Disengage the 5 claws, 3 clips and guide, and remove the rear door scuff plate LH.
| 4. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP |
![]() |
Remove the rear door opening trim weatherstrip LH.
| 5. REMOVE DECK BOARD ASSEMBLY |
![]() |
Remove the deck board assembly.
| 6. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY |
![]() |
Disengage the 2 guides and remove the No. 3 deck board sub-assembly.
| 7. REMOVE NO. 2 DECK BOARD SUB-ASSEMBLY |
![]() |
Disengage the 2 guides and remove the No. 2 deck board sub-assembly.
| 8. REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover) |
Remove the tonneau cover assembly.
| 9. REMOVE REAR NO. 1 FLOOR BOARD (w/o Rear No. 2 Seat) |
![]() |
Disengage the 3 clips and the 3 guides, and remove the rear No. 1 floor board.
| 10. REMOVE REAR SEAT SIDE COVER LH (w/ Rear No. 2 Seat) |
![]() |
Disengage the 2 clips and remove the rear seat side cover LH.
| 11. REMOVE DECK SIDE TRIM BOX LH |
![]() |
Remove the 2 deck side trim clips and clip.
Remove the deck side trim box LH as shown in the illustration.

| 12. REMOVE REAR SEAT SIDE COVER RH (w/ Rear No. 2 Seat) |
![]() |
Disengage the 2 clips and remove the rear seat side cover RH.
| 13. REMOVE JACK CARRIER SUPPORT |
| 14. REMOVE JACK CARRIER CUSHION |
![]() |
Remove the jack carrier cushion.
| 15. REMOVE JACK ASSEMBLY |
![]() |
Remove the jack assembly.
| 16. REMOVE JACK CARRIER ASSEMBLY |
![]() |
Using a screwdriver, disengage the 3 claws and remove the jack carrier assembly.
| 17. REMOVE DECK SIDE TRIM BOX RH |
![]() |
Remove the 2 deck side trim clips and clip.
Remove the deck side trim box RH as shown in the illustration.

| 18. REMOVE REAR MAT |
![]() |
Remove the rear mat.
| 19. REMOVE DECK FLOOR BOARD ASSEMBLY (w/o Rear No. 2 Seat) |
![]() |
Remove the 4 bolts and 4 nuts.
Remove the deck floor board assembly.
| 20. REMOVE DECK FLOOR BOARD ASSEMBLY (w/ Rear No. 2 Seat) |
![]() |
Disengage the 3 claws.
Remove the 2 nuts and the deck floor board assembly.
| 21. REMOVE REAR DECK FLOOR BOX (w/o Rear No. 2 Seat) |
![]() |
Remove the 2 nuts and the deck floor box.
| 22. REMOVE NO. 1 DECK BOARD (w/o Rear No. 2 Seat) |
![]() |
Disengage the 3 clips and remove the No. 1 deck board from the rear floor board spacer.
| 23. REMOVE NO. 1 DECK BOARD (w/ Rear No. 2 Seat) |
![]() |
Disengage the 5 clips and remove the No. 1 deck board from the rear deck floor box.
| 24. REMOVE REAR NO. 2 SEAT INNER BELT ASSEMBLY (w/ Rear No. 2 Seat) |
![]() |
Remove the bolt and rear No. 2 seat inner belt assembly.
| 25. DISCONNECT REAR SEAT LAP TYPE BELT ASSEMBLY LH (w/ Rear No. 2 Seat) |
![]() |
Remove the bolt and disconnect the rear seat lap type belt assembly LH.
| 26. DISCONNECT REAR SEAT LAP TYPE BELT ASSEMBLY RH (w/ Rear No. 2 Seat) |
| 27. REMOVE REAR NO. 2 SEAT ASSEMBLY (w/ Rear No. 2 Seat) |
![]() |
Remove the 4 bolts and the rear No. 2 seat assembly.
| 28. REMOVE REAR FLOOR FINISH PLATE |
![]() |
Disengage the 4 clips and the 4 claws, and remove the rear floor finish plate.
| 29. REMOVE REAR SEAT SIDE GARNISH CAP (for RH Side without Rear Air Conditioning System) |
![]() |
Disengage the 8 claws and guide, and remove the rear seat side garnish cap.
| 30. REMOVE REAR SEAT SIDE GARNISH CAP (for RH Side with Rear Air Conditioning System) |
![]() |
Remove the screw.
Disengage the 6 claws and the guide, and remove the rear seat side garnish cap.
| 31. REMOVE DECK SIDE TRIM COVER |
![]() |
Using a screwdriver, disengage the 2 claws and remove the deck side trim cover LH.
| 32. REMOVE DECK SIDE TRIM |
![]() |
Remove the bolt.
![]() |
Disengage the 4 claws and the 3 guides, and remove the deck side trim LH as shown in the illustration.
| 33. REMOVE SIDE TRIM COVER LH (for LH Side without Rear Seat Entertainment System) |
![]() |
Disengage the 10 claws and remove the side trim cover LH.
| 34. REMOVE POWER OUTLET SOCKET BEZEL (for LH Side with Rear Seat Entertainment System) |
![]() |
Disengage the 4 claws.
![]() |
Disconnect each connector and remove the power outlet socket bezel.
| 35. REMOVE SIDE TRIM COVER RH (for RH Side without Rear Automatic Air Conditioning System) |
![]() |
Disengage the 4 claws and remove the side trim cover RH.
| 36. REMOVE REAR ROOM TEMPERATURE SENSOR (for RH Side with Rear Automatic Air Conditioning System) |
![]() |
Disengage the 4 claws and remove the rear room temperature sensor.
Disconnect the connector.
| 37. REMOVE REAR COMBINATION LIGHT SERVICE COVER LH (for LH Side) |
![]() |
Using a screwdriver, disengage the 6 claws and 2 guides, and remove the rear combination light service cover LH.
| 38. REMOVE REAR COMBINATION LIGHT SERVICE COVER RH (for RH Side) |
![]() |
Using a screwdriver, disengage the 6 claws and the 2 guides, and remove the rear combination light service cover RH.
| 39. REMOVE REAR POWER POINT SOCKET ASSEMBLY (for LH Side) |
Disconnect the connector.
![]() |
Disengage the claw and remove the rear power point socket assembly.
| 40. REMOVE REAR POWER OUTLET SOCKET COVER (for LH Side) |
![]() |
Disengage the 2 claws and remove the rear power outlet socket cover.
| 41. REMOVE REAR DECK TRIM COVER (for LH Side without Remote Folding Function) |
![]() |
Disengage the 10 claws and remove the rear deck trim cover.
| 42. REMOVE RECLINING REMOTE CONTROL BEZEL (for LH Side with Remote Folding Function) |
![]() |
Disengage the 5 claws and remove the reclining remote control bezel LH.
| 43. REMOVE ROPE HOOK ASSEMBLY |
![]() |
for Front Side:
Using a screwdriver, disengage the 2 claws.
Remove the bolt and the rope hook assembly.
![]() |
for Rear Side:
Using a screwdriver, disengage the 2 claws.
Remove the bolt and rope hook assembly.
| 44. REMOVE NO. 2 DECK SIDE TRIM HOOK (for LH Side) |
![]() |
Remove the screw and the No. 2 deck side trim hook.
| 45. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK (for RH Side) |
| 46. REMOVE FRONT DECK SIDE TRIM COVER |
![]() |
Using a screwdriver, disengage the 4 claws and remove the 2 front deck side trim covers LH.
| 47. DISCONNECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY |
![]() |
Remove the bolt and disconnect the floor end of the rear No. 1 seat outer belt assembly.
| 48. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH (for LH Side) |
Remove the 2 bolts.
Remove the 2 clips.
Disengage the 7 claws and 4 clips, and remove the deck trim side panel assembly LH.

| 49. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH (for RH Side) |
Remove the 3 bolts.
Remove the 2 clips.
Disengage the 7 claws and 4 clips, and remove the deck trim side panel assembly RH.

| 50. REMOVE REAR AIRBAG SENSOR |
![]() |
Disconnect the connector from the rear airbag sensor.
Remove the bolt and disengage the pin, and remove the rear airbag sensor.