CURTAIN SHIELD AIRBAG ASSEMBLY > DISPOSAL |
| 1. PRECAUTION |
| 2. DISPOSE OF CURTAIN SHIELD AIRBAG ASSEMBLY (WHEN INSTALLED IN VEHICLE) |
![]() |
Check the function of SST .
Refer to PRECAUTION (Click here).
Disconnect the cable from the negative battery terminal.
Remove the roof headlining assembly (Click here).
Install SST.
Disconnect the connector from the curtain shield airbag assembly.
![]() |
After connecting the following SST to each other, connect them to the curtain shield airbag assembly.
![]() |
Move SST at least 10 m (33 ft.) away from the vehicle rear side window.
Maintaining enough clearance for the SST wire harness in the rear side window, close all doors and windows of the vehicle.
Connect the red clip of SST to the battery positive (+) terminal and the black clip of SST to the battery negative (-) terminal.
Deploy the airbag.
Check that no one is inside the vehicle or within a 10 m (33 ft.) radius of the vehicle.
Press the SST activation switch and deploy the airbag.
| 3. DISPOSE OF CURTAIN SHIELD AIRBAG ASSEMBLY (WHEN NOT INSTALLED IN VEHICLE) |
![]() |
Check the function of SST .
Remove the curtain shield airbag assembly (Click here).
![]() |
Cut off the deployment section of the curtain shield airbag assembly.
![]() |
Using braided wire, tie down the curtain shield airbag assembly to an unneeded tire.
![]() |
Position the curtain shield airbag assembly inside the tire as shown in the illustration.
Install SST.
![]() |
After connecting the following SST to each other, connect them to the curtain shield airbag assembly.
Place the tires.
![]() |
Place at least 2 tires under the tire which the curtain shield airbag assembly is tied to.
Place at least 2 tires over the tire which the curtain shield airbag assembly is tied to. The top tire should have a wheel installed.
![]() |
Tie the tires together with the 2 wires.
Install SST.
![]() |
Connect the SST connector.
Move SST at least 10 m (33 ft.) away from the airbag tied down to the tire.
Deploy the airbag.
Connect the red clip of SST to the battery positive (+) terminal and the black clip of SST to the battery negative (-) terminal.
Check that no one is within a 10 m (33 ft.) radius of the tire which the curtain shield airbag assembly is tied to.
Press the SST activation switch and deploy the airbag.
![]() |
Dispose of the curtain shield airbag assembly.
Remove the curtain shield airbag assembly from the tire.
Place the curtain shield airbag assembly in a plastic bag, tie it tightly, and dispose of it according to local regulations.