Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM (w/ Smart Key System)

ENGINE IMMOBILISER SYSTEM (w/ Smart Key System) > ID Code Box Power Source Circuit

for Preparation Click here


DESCRIPTION

This circuit provides power to operate the ID code box (immobiliser code ECU).

WIRING DIAGRAM


B151008E03


INSPECTION PROCEDURE

NOTICE:
If the ID code box (immobiliser code ECU) is replaced, register the ECU code and ECU communication ID (Click here).

1.CHECK HARNESS AND CONNECTOR (ID CODE BOX - BATTERY)


    B107455E34
  1. Disconnect the ID code box (immobiliser code ECU) connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    D31-1 (+B) - Body ground
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR, OR REPLACE FUSE
OK


2.CHECK HARNESS AND CONNECTOR (ID CODE BOX - BODY GROUND)


    B107455E35
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D31-8 (GND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ID CODE BOX (IMMOBILISER CODE ECU) (Click here)