Home › TRANSMISSION ยท U151E AUTOMATIC TRANSAXLE › AUTOMATIC TRANSAXLE SYSTEM

AUTOMATIC TRANSAXLE SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. The ECM of this system is connected to the CAN and multiplex communication system. Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN and multiplex communication systems.
  2. *: Use Techstream



1.Vehicle Brought to Workshop

    NEXT


    2.Customer Problem Analysis

      NEXT


      3.Inspect Battery Voltage

        Standard voltage:
        11 to 14 V

        If the voltage is below 11 V, recharge or replace the battery before proceeding.

      NEXT


      4.Connect Techstream to the DLC3*

        NEXT


        5.Check and Clear DTCs and Freeze Frame Data*

          HINT:
          (Click here).


        NEXT


        6.Visual Inspection

          NEXT


          7.Setting the Check Mode Diagnosis*

            HINT:
            (Click here).


          NEXT


          8.Problem Symptom Confirmation

            HINT:
            (Click here).

            Result:
            Result
            Proceed to
            Symptom does not occur
            A
            Symptom occurs
            B



          B.
          Go to step 10
          A


          9.Symptom Simulation

            HINT:
            (Click here).


          NEXT


          10.DTC Check*

            HINT:
            (Click here).

            Result:
            Result
            Proceed to
            DTC is not output
            A
            DTC is output
            B



          B.
          Go to step 18
          A


          11.Basic Inspection

            HINT:
            (Click here, Click here and Click here).



          NG.
          Go to step 21
          OK


          12.Mechanical System Test

            HINT:
            (Click here).



          NG.
          Go to step 17
          OK


          13.Hydraulic Test

            HINT:
            (Click here).



          NG.
          Go to step 17
          OK


          14.Manual Shifting Test

            HINT:
            (Click here).



          NG.
          Go to step 16
          OK


          15.Problem Symptoms Table Chapter 1

            HINT:
            (Click here).



          NG.
          Go to step 19
          OK


          16.Problem Symptoms Table Chapter 2

            HINT:
            (Click here).


          NEXT


          17.Part Inspection

            NEXT

            Go to step 21


            18.DTC Chart

              HINT:
              (Click here).


            NEXT


            19.Circuit Inspection

              NEXT


              20.Identification of Problem

                NEXT


                21.Repair or Replace

                  NEXT


                  22.Confirmation Test

                    NEXT

                    End