AUTOMATIC TRANSAXLE SYSTEM > CHECK MODE PROCEDURE |
| DTC CHECK (CHECK MODE) |
Procedure for Check Mode using Techstream.
Check the initial conditions.
Turn the ignition switch off.
Connect Techstream to the DLC3.
![]() |
Turn the ignition switch on (IG) and turn the Techstream main switch ON.
Enter the following menus: Powertrain / Engine and ECT / Utility / Check Mode.
Start the engine (the MIL goes off after the engine starts).
Perform "MONITOR DRIVE PATTERN" for the ECT test (Click here), or simulate the conditions of the malfunction described by the customer.
After simulating malfunction conditions, use the Techstream diagnosis selector to check the DTCs and freeze frame data, etc.
When you use Techstream: Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
After checking the DTC, inspect the applicable circuit.
(Click here) to confirm the details of the DTCs.
| DTC CLEAR |
When using Techstream: Clearing the DTCs.
Connect Techstream to the DLC3.
Turn the ignition switch on (IG) and turn the Techstream main switch ON.
When you use Techstream: Enter the following menus: Powertrain / Engine and ECT / Trouble Codes / Clear.
When not using Techstream: Clearing the DTCs.
Disconnect the battery cable or remove the EFI and ETCS fuses from the engine room junction block for 60 seconds or more. However, if you disconnect the battery cable, perform do the "INITIALIZATION (Click here)" procedure.