Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE AND WHEEL SYSTEM

TIRE AND WHEEL SYSTEM > INSPECTION

for Preparation Click here



1. INSPECT TIRE
  1. Check the tires for wear and proper inflation pressure.

    Cold tire inflation pressure:

    for USA, CANADA 
    Tire size
    Front kPa (kgf/cm2, psi)
    Rear kPa (kgf/cm2, psi)
    P245/55R19 103S
    P245/65R17 105S
    210 (2.1, 30)
    210 (2.1, 30)
    210 (2.1, 30)
    210 (2.1, 30)


    Cold tire inflation pressure:

    for MEXICO 
    Tire size
    Front kPa (kgf/cm2, psi)
    Rear kPa (kgf/cm2, psi)
    P245/55R19 103S
    P245/65R17 105S
    4 passengers or less
    210 (2.1, 30)
    210 (2.1, 30)
    5 passengers or more
    210 (2.1, 30)
    230 (2.3, 33)



    C137874
  1. Using a dial indicator, check the runout of the tires.

    Tire runout:
    1.4 mm (0.055 in.) or less



2. ROTATE TIRES


    C135236E01
  1. Rotate the tires as shown in the illustration (A). If the vehicle is equipped with a grand spare tire, rotate the tires as shown in the illustration (B).



3. INSPECT WHEEL BALANCE


  1. Check and adjust the off-the-car balance.


    C163164E01

    Imbalance after adjustment:
    8.0 g (0.018 lb) or less

    NOTICE:
    1. Remove dirt, oil, and water from the surface where the balance weight is to be adhered with a cleaning detergent.
    2. Do not touch the sticking surface of the tape.
    3. Adhere the sticking type balance weight to the flat position shown in the illustration.
    4. Push the balance weight securely with a finger to adhere it to the indicated position.
    5. Do not reuse balance weights.

    HINT:
    1. For 19-inch wheels both inner side and outer side balance weight are sticking type.
    2. For 17-inch wheels the inner side balance weight should be installed by clipping it to the rim.
    3. If necessary, check and adjust wheel balance using an on-the-car balancer.



4. INSPECT FRONT AXLE HUB BEARING LOOSENESS

HINT:
Click here.



5. INSPECT REAR AXLE HUB BEARING LOOSENESS (for 2WD)

HINT:
Click here.



6. INSPECT REAR AXLE HUB BEARING LOOSENESS (for 4WD)

HINT:
Click here.



7. INSPECT FRONT AXLE HUB RUNOUT

HINT:
Click here.



8. INSPECT REAR AXLE HUB RUNOUT (for 2WD)

HINT:
Click here.



9. INSPECT REAR AXLE HUB RUNOUT (for 4WD)

HINT:
Click here.