VEHICLE STABILITY CONTROL SYSTEM > FREEZE FRAME DATA |
| FREEZE FRAME DATA |
Whenever an ABS DTC is detected, the skid control ECU stores the current vehicle (sensor) state as Freeze Frame Data.
The skid control ECU stores the number of times (maximum: 31) the ignition switch has been turned from off to on (IG) since the last time the ABS was activated.
| CHECK FREEZE FRAME DATA |
Connect Techstream to the DLC3.
Turn the ignition switch on (IG).
Turn Techstream on.
Enter the following menus: Chassis / ABS/VSC/TRAC / Trouble Codes.
According to the display on the tester, select the trouble code data display with Freeze Frame Data.
| Tester Display | Measurement Item | Reference Value |
| Elapsed Time after Freeze Trigger | Elapsed time after freeze frame trigger | Min.: 0 ms, Max.: 500 ms |
| Number of IG ON | Number of operations of ignition switch being turned on (IG) after storing Freeze Frame Data | 0 to 31 |
| Buzzer | Skid control buzzer signal | Skid control buzzer ON: ON, OFF: OFF |
| Stop Light SW | Stop light switch signal | Stop light switch ON: ON, OFF: OFF |
| Parking Brake SW | Parking brake switch signal | Parking brake switch ON: ON, OFF: OFF |
| TRC (TRAC)/VSC OFF SW | VSC OFF switch signal | VSC OFF switch ON: OFF, OFF: ON |
| Gear Position | Gear position information | FAIL 1st 2nd 3rd 4th 5th 6th 7th 8th P, N R NOT R |
| Shift Lever Position | Shift lever position information | FAIL 1st 2nd 3rd 4th 5th 6th/B D/M P, N R |
| Operated System | Operated system status | ABS: ABS activated VSC: VSC activated TRC: TRAC activated BA: BA activated HAB: HAB activated HA-CTRL: Hill-start assist control activated FAIL: Fail safe mode activated SYS: System prohibit activated NON: No operation activated |
| Master Cylinder Sensor | Master cylinder pressure sensor reading | Brake pedal released: 0.3 to 0.9 V Brake pedal depressed: 0.8 to 4.5 V |
| M/C Sensor Grade | Master cylinder pressure sensor change | Min.: -30 MPa/s, Max.: 225 MPa/s |
| Yaw Rate Sensor | Yaw rate sensor reading | Min.: -128 deg/s, Max.: 127 deg/s |
| Lateral G | Lateral G | Min.: -25.11 m/s2, Max.: 24.91 m/s2
|
| Forward and Rearward G | Forward and backward G | Min.: -25.11 m/s2, Max.: 24.91 m/s2
|
| FR Wheel Speed | FR wheel speed | Min.: 0 km/h (0 mph), Max.: 326.4 km/h (202 mph) |
| FL Wheel Speed | FL wheel speed | Min.: 0 km/h (0 mph), Max.: 326.4 km/h (202 mph) |
| RR Wheel Speed | RR wheel speed | Min.: 0 km/h (0 mph), Max.: 326.4 km/h (202 mph) |
| RL Wheel Speed | RL wheel speed | Min.: 0 km/h (0 mph), Max.: 326.4 km/h (202 mph) |
| Vehicle Speed | Vehicle speed reading | Min.: 0 km/h (0 mph), Max.: 326.4 km/h (202 mph) |
| Vehicle Speed Grade | Vehicle speed grade | Min.: -25.11 m/s2, Max.: 24.91 m/s2
|
| Real Engine Torque | Real engine torque | Min.: -1024 Nm, Max.: 1023 Nm |
| Accelerator Opening Angle % | Accelerator opening Angle % | Min.: 0 %, Max.: 128 % |
| Brake Pedal Load Sensing SW | Brake pedal load sensing switch signal | Brake pedal load sensing switch ON: ON, OFF: OFF |
| Inspection Mode | Inspection mode | OTHER: Normal mode INSPECT: Inspection mode |
| Steering Angle Sensor | Steering angle sensor reading | Left turn: Increase Right turn: Decrease |
| TRC/VSC Off Mode | TRAC/VSC off mode | NORMAL: Normal mode TRC OFF: TRAC off mode VSC OFF: VSC off mode |
| CLEAR FREEZE FRAME DATA |
Connect Techstream to the DLC3.
Turn the ignition switch on (IG).
Clear the DTCs and Freeze Frame Data (Click here).