Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

DTC    C1203    ECM Communication Circuit Malfunction

for Preparation Click here


DESCRIPTION

The circuit is used to send TRAC and VSC control information from the skid control ECU to the ECM, and engine control information from the ECM to the skid control ECU through the CAN communication system.

DTC Code
DTC Detection Condition
Trouble Area
C1203
Engine, drive source and destination variations that are sent from the ECM do not match the ones of the skid control ECU.
ECM

INSPECTION PROCEDURE

1.CHECK PART NUMBER (ECM AND BRAKE ACTUATOR ASSEMBLY)
  1. Check that the proper ECM and brake actuator assembly (skid control ECU) are installed.

    OK:
    Proper ECUs are installed.



NG
REPLACE ECUS WITH PROPER ONES
OK

REPLACE ECM (for 2GR-FE) (Click here)