Home › ENGINE › 2GR-FE ENGINE CONTROL SYSTEM › ECM

ECM > REMOVAL

for Preparation Click here


NOTICE:
Before removing the tire pressure warning ECU, read the registered transmitter IDs of all wheels and write them down to use for re-registration of transmitter IDs (Click here).



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE FRONT DOOR SCUFF PLATE RH

HINT:
Use the same procedure for the RH side and the LH side .



3. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH

HINT:
Use the same procedure for the RH side and the LH side .



4. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    B172999
  1. Disengage the 3 claws.

  1. Disengage the 2 guides and remove the No. 2 instrument panel under cover sub-assembly.



5. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY


    B168370
  1. Remove the 2 bolts <B> and 3 screws <F>.

  1. Disengage the 4 claws and 3 clips.

  1. Disconnect each connector and clamp, and remove the lower instrument panel sub-assembly.



6. REMOVE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) (w/ Smart Key System)


    B170919
  1. Disconnect the connectors.

  1. Remove the 2 nuts and the certification ECU (smart key ECU assembly).



7. REMOVE TIRE PRESSURE WARNING ECU


    C165671
  1. Remove the nut.



    C165672
  1. Disconnect the connector and remove the tire pressure warning ECU.



8. REMOVE ECM
  1. Separate the harness connector.

  1. Disconnect the 5 ECM connectors.



    A171719
  1. Remove the wire harness clamp.

  1. Remove the 2 nuts, bolt and ECM.



9. REMOVE NO. 1 ECM BRACKET


    A171737
  1. Remove the 2 screws and No. 1 ECM bracket.



10. REMOVE NO. 2 ECM BRACKET


    A171738
  1. Remove the 2 screws and No. 2 ECM bracket.