DTC C1432 Steering Angle Sensor Power Source Voltage Malfunction |
| DTC Code | DTC Detection Condition | Trouble Area |
| C1432 | Steering angle sensor power supply malfunction signal is received from steering angle sensor. |
|

| 1.INSPECT STEERING ANGLE SENSOR (POWER SOURCE TERMINAL) |
![]() |
Remove the steering wheel and the column cover lower.
Make sure that there is no looseness at the locking part and the connecting part of the connectors.
Disconnect the steering angle sensor connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| D14-4 (IG1) - Body ground | Ignition switch on (IG) | 11 to 14 V |
| D14-5 (BAT) - Body ground | Always | 11 to 14 V |
|
| ||||
| OK | |
| 2.INSPECT STEERING ANGLE SENSOR (GROUND TERMINAL) |
![]() |
Turn the ignition switch off.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D14-1 (ESS) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||