Home › BRAKE › BRAKE CONTROL › STEERING ANGLE SENSOR

STEERING ANGLE SENSOR > REMOVAL

for Preparation Click here



1. PRECAUTION
(Click here)


2. FRONT WHEELS FACING STRAIGHT AHEAD


3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected. (Click here)



4. REMOVE LOWER NO. 3 STEERING WHEEL COVER


    C165090
  1. Disengage the claw and remove the lower No. 3 steering wheel cover.



5. REMOVE LOWER NO. 2 STEERING WHEEL COVER


    C165091
  1. Disengage the claw and remove the lower No. 2 steering wheel cover.



6. REMOVE STEERING PAD


    C166981E01
  1. Using a "TORX" socket wrench (T30), loosen the 2 "TORX" screws until the groove along the screw circumference catches on the screw case.



    C165092
  1. Pull out the steering pad from the steering wheel assembly and support the steering pad with one hand as shown in the illustration.

    NOTICE:
    When removing the steering pad, do not pull the airbag wire harness.



    C165094E01
  1. Disconnect the horn connector from the steering pad.

  1. Using a screwdriver with the tip wrapped with protective tape, disconnect the 2 airbag connectors and remove the steering pad.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



7. REMOVE STEERING WHEEL ASSEMBLY


    C165708E01
  1. Remove the steering wheel assembly set nut.

  1. Put matchmarks on the steering wheel assembly and the steering main shaft.

  1. Disconnect the connectors from the spiral cable.



    C165709E01
  1. Using SST, remove the steering wheel assembly.

    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05021)

    NOTICE:
    Apply a small amount of grease to the threads and tip of SST (09953-05020) before use.



8. REMOVE STEERING COLUMN COVER


    C165715
  1. Remove the 2 screws.



    C166128
  1. Disengage the 2 claws to remove the lower steering column cover.



    C165716
  1. Disengage the claw to remove the upper steering column cover.



9. REMOVE SPIRAL CABLE WITH STEERING ANGLE SENSOR


    C165095
  1. Disconnect the connectors from the spiral cable with steering angle sensor.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Disengage the 3 claws and remove the spiral cable with steering angle sensor.



10. REMOVE STEERING ANGLE SENSOR


    C155277E02
  1. Disengage the 6 claws and 2 pins, and remove the steering angle sensor from the spiral cable.