TIRE PRESSURE WARNING SYSTEM > PRECAUTION |
| 1.TIRE PRESSURE WARNING SYSTEM PRECAUTION |
![]() |
When the tire pressure warning light comes on, immediately check the tire pressure of the tire and adjust it to the specified value.
| Tire size | Front kPa (kgf/cm2, psi) | Rear kPa (kgf/cm2, psi) |
| P245/55R19 103S P245/65R17 105S | 210 (2.1, 30) | 210 (2.1, 30) |
| 210 (2.1, 30) | 210 (2.1, 30) |
| Tire size | Front kPa (kgf/cm2, psi) | Rear kPa (kgf/cm2, psi) | |
| P245/55R19 103S P245/65R17 105S | 4 passengers or less | 210 (2.1, 30) *1
220 (2.2, 32) *2 | 210 (2.1, 30) *1
220 (2.2, 32) *2 |
| 5 passengers or more | 210 (2.1, 30) *1
220 (2.2, 32) *2 | 230 (2.3, 33) *1
240 (2.4, 35) *2 | |
When the tire pressure warning light comes on after blinking for 1 minute, there is a malfunction in the system. Check for DTCs.
It is necessary to register the transmitter ID in the tire pressure warning ECU after replacing a tire pressure warning valve and transmitter and/or tire pressure warning ECU (Click here).
When replacing the tire pressure warning ECU:
Using the DATA LIST, read the transmitter IDs registered in the ECU and make a note of them before removing the tire pressure warning ECU.
Register the transmitter IDs after installing a new tire pressure warning ECU.
When replacing a tire pressure warning valve and transmitter:
Take note of the 7-digit number (transmitter ID) written on the new tire pressure warning valve and transmitter when replacing it. Register the transmitter IDs in the tire pressure warning ECU after replacing the tire pressure warning valve and transmitter and installing the tires onto the wheels.

When replacing the tire pressure warning ECU and a tire pressure warning valve and transmitters, it is necessary to perform the initialization (Click here) after the registration (Click here).
Precautions about the tire pressure:
| 2.IN CASE OF TIRE AND WHEEL REPLACEMENT |
When tires and wheels are replaced, always ensure that each transmitter ID is correctly registered.
| 3.INITIALIZATION PRECAUTION |
Initialize the tire pressure warning system after any of the following is performed:
| 4.FAIL-SAFE FUNCTION |
When a system malfunction occurs in the tire pressure warning system, the tire pressure warning light comes on after blinking for 1 minute and informs the driver of the system failure.
The result of this diagnosis is stored in the tire pressure warning ECU.
| 5.CHECK TIRE PRESSURE AFTER REPAIRS |
After repairs, confirm that the actual tire pressures are displayed in DATA LIST (Click here).