When the tire pressure warning light does not go off, or when it comes on during driving, check tire pressure. If the tire pressure warning light comes on after adjusting the tire pressure, the tire may have a slow air leak.
The system will be disabled in the following conditions: (When the condition becomes normal, the system will work properly.)
- The tires without tire pressure warning valve and transmitters are used.
- The ID of a tire pressure warning valve and transmitter has not been registered in the ECU.
- The tire pressure is abnormally high (absolute pressure: 600 kPa (6 kgf/cm2, 87 psi) or more; relative pressure: 500 kPa (5 kgf/cm2, 72.5 psi) or more).
- The battery of the sensor has been depleted.
The system may be disabled in the following conditions: (When the condition becomes normal, the system will work properly.)
- Facilities or devices that use similar radio frequencies are located in the vicinity of the vehicle.
- A radio device of similar frequency is used in the vehicle.
- A film or window tint that may interfere with radio waves is attached on the glass.
- A large amount of snow or ice is stuck to the vehicle, especially onto the wheels and around the wheel wells.
- Use of non-genuine wheels may result in the system failure or air-leak.
- Tire chains are used.
- If the spare tire is in a location subject to poor radio wave reception.
- If a large metallic object which can interfere with signal reception is put in the trunk.
When the full-size spare tire is not within the receivable range of the electric wave, a signal may not be received because the full-size spare tire is fixed. Accordingly, the system may not function properly. If there is a possibility that the tire pressure warning system does not receive a signal from the full-size spare tire, rotate the tire 90 to 270°.
After removing and installing the ECU or a sensor, check for a diagnostic trouble code and verify that it is a normal system code.
Components
| Function
|
Tire pressure warning valve and transmitter
| Combined as a single unit with a disc wheel air valve, it measures tire pressure and temperature and transmits an ID number for measurement value and identification. Built-in the battery.
|
Tire pressure warning antenna and receiver
| Receives and transmits a necessary signal from the transmitters to the tire pressure warning ECU.
|
Tire pressure warning ECU
| Receives a signal from the receiver and identifies it as vehicle's own signal. If the measured value is equal to or lower than the specified value, it transmits a signal to illuminate the tire pressure warning light on the combination meter comes on.
|
Tire pressure warning light
| Located in the combination meter, it informs the driver of lowered tire pressure and system failure.
|
Tire pressure warning reset switch
| Enters the initialization mode.
|