TIRE PRESSURE WARNING SYSTEM > DTC CHECK / CLEAR |
| DTC CHECK (USING SST CHECK WIRE) |
Turn the ignition switch off.

Using SST, connect terminals TC and CG of the DLC3.
Turn the ignition switch on (IG).
Read and record any DTCs from the tire pressure warning light on the combination meter. Refer to the illustration as examples of the normal system code and codes 13 and 33.
| Trouble Area | See procedure |
| Tire pressure warning light circuit |
Click here
|
| TC and CG terminal circuit |
Click here
|
Refer to the Diagnostic Trouble Code Chart (Click here) for DTC information.
After completing the check, turn the ignition switch off and remove SST from the DLC3.
| DTC CHECK (USING TECHSTREAM) |
Turn the ignition switch off.
Connect Techstream to the DLC3.
Turn the ignition switch on (IG) and turn the tester on.
Enter the following menus: Chassis / Tire Pressure Monitor / Trouble Codes.
Read the DTCs following the prompts on the tester screen.
| CLEAR DTC |
Turn the ignition switch off.
Connect Techstream to the DLC3.
Turn the ignition switch on (IG) and turn the tester on.
Enter the following menus: Chassis / Tire Pressure Monitor / Trouble Codes.
Clear the DTCs following the prompts on the tester screen.