TIRE PRESSURE WARNING SYSTEM > ECU Power Source Circuit |

| 1.INSPECT FUSE (ECU-IG NO. 1) |
Remove the ECU-IG NO. 1 fuse from the instrument panel junction block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| ECU-IG NO. 1 | Always | Below 1 Ω |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (ECU - BATTERY) |
![]() |
Disconnect the D33 ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| D33-7 (IG) - Body ground | Ignition switch on (IG) | 11 to 14 V |
| Ignition switch off | Below 1 V |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (ECU - BODY GROUND) |
![]() |
Disconnect the D33 ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D33-9 (GND) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||
| 4.CHECK HARNESS AND CONNECTOR (ECU - FUSE) |
![]() |
Disconnect the D33 ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D33-7 (IG) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||