Home › STEERING › STEERING COLUMN › STEERING LOCK SYSTEM

STEERING LOCK SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Perform troubleshooting in accordance with the following flowchart.
  1. *: Use Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

    NEXT


    3.CHECK AND CLEAR DTCS*

      NEXT


      4.PROBLEM SYMPTOM CONFIRMATION

        Result:
        Result
        Proceed to
        Symptom does not occur
        A
        Symptom occurs
        B



      B.
      GO TO STEP 6
      A


      5.SYMPTOM SIMULATION

        NEXT


        6.CHECK CAN COMMUNICATION SYSTEM*

          HINT:
          Check that there are no problems in the CAN communication system before troubleshooting the steering lock system.


        NEXT


        7.DTC CHECK*
        1. Check for DTCs (Click here).

          Result:
          Result
          Proceed to
          DTC is output.
          A
          DTC is not output.
          B



        A.
        GO TO STEP 9
        B


        8.PROBLEM SYMPTOMS TABLE

          Result:
          Result
          Proceed to
          Fault is not listed in problem symptoms table
          A
          Fault is listed in problem symptoms table
          B



        B.
        Go TO STEP 10
        A


        9.DTC CHART

          NEXT


          10.CIRCUIT INSPECTION*

            NEXT


            11.PROBLEM IDENTIFICATION

              NEXT


              12.REPAIR OR REPLACEMENT

                NEXT


                13.CONFIRMATION TEST*

                  NEXT

                  END