DTC B2278 Engine Switch Circuit Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| B2278 | Communication is abnormal between the main body ECU (instrument panel junction block) and engine switch or the engine switch is defective |
|

| 1.READ VALUE USING TECHSTREAM (START SWITCH) |
Connect Techstream to the DLC3.
Check the DATA LIST for proper functioning of the start switch.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| St SW1 | Start Switch 1 / ON or OFF | ON: Engine switch is pushed OFF: Engine switch is not pushed | - |
| St SW2 | Start Switch 2 / ON or OFF | ON: Engine switch is pushed OFF: Engine switch is not pushed | - |
|
| ||||
| OK | ||
| ||
| 2.INSPECT ENGINE SWITCH |
Remove the engine switch (Click here).

Disconnect the switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 7 (SS1) - 5 (GND) | Pushed | Below 1 Ω |
| 2 (SS2) - 5 (GND) | Pushed | Below 1 Ω |
| 7 (SS1) - 5 (GND) | Not pushed | 10 kΩ or higher |
| 2 (SS2) - 5 (GND) | Not pushed | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (ENGINE SWITCH - MAIN BODY ECU AND BODY GROUND) |
Disconnect the D8 ECU connector.

Disconnect the D25 switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D25-7 (SS1) - D8-17 (SSW1) | Always | Below 1 Ω |
| D25-2 (SS2) - D8-16 (SSW2) | Always | Below 1 Ω |
| D25-5 (GND) - Body ground | Always | Below 1 Ω |
| D25-7 (SS1) or D8-17 (SSW1) - Body ground | Always | 10 kΩ or higher |
| D25-2 (SS2) or D8-16 (SSW2) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||