Home › ENGINE › 2GR-FE STARTING › IGNITION SWITCH

IGNITION SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL IGNITION SWITCH ASSEMBLY


    A170653
  1. Engage the 2 claws to install the ignition switch.



    A170652
  1. Connect the ignition switch connector.



2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (for Automatic Air Conditioning System)


    B173009
  1. Connect the hood lock control cable assembly.

  1. Connect each connector and the aspirator duct.



    B173021
  1. Engage the 3 claws and 10 clips.

  1. Install the lower instrument panel finish panel sub-assembly with the 2 bolts <B>.



3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (for Manual Air Conditioning System)


    B168371
  1. Connect the hood lock control cable assembly.

  1. Connect each connector.

  1. Engage the 3 claws and 10 clips.

  1. Install the lower instrument panel finish panel sub-assembly with the 2 bolts <B>.



4. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH


    B173227
  1. Engage the claw and clip, install the cowl side trim sub-assembly LH.

  1. Install the clip.



5. INSTALL FRONT DOOR SCUFF PLATE LH


    B173224
  1. Engage the guide and the 8 claws, and install the front door scuff plate LH.



6. INSTALL STEERING COLUMN COVER LOWER


    A170657
  1. Engage the 2 claws to install the steering column cover lower.



    A170651
  1. Insert the key into the ignition key cylinder and release the steering lock.

  1. Turn the steering wheel counterclockwise and install the screw.



    A170650
  1. Turn the steering wheel clockwise and install the screw.



7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).