DTC B2782 Power Source Control ECU Malfunction |
| DTC No. | DTC Detecting Condition | Trouble Area |
| B2782 | Steering lock motor drive control circuit is defective. |
|

| 1.INSPECT STEERING LOCK ACTUATOR ASSEMBLY (STEERING LOCK ECU) |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D11-3 (IGE) - D11-1 (GND) | The specified condition should be checked after performing the following:
|
|
| D11-3 (IGE) - D11-1 (GND) | The specified condition should be checked after performing the following:
|
|
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (STEERING LOCK ACTUATOR ASSEMBLY - BODY GROUND) |
![]() |
Disconnect the D11 connector from the steering lock actuator assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| D11-1 (GND) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (STEERING LOCK ACTUATOR ASSEMBLY - MAIN BODY ECU) |
![]() |
Disconnect the D8 connector from the main body ECU.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| D11-3 (IGE) - D8-19 (SLR+) | Always | Below 1 Ω |
| D11-3 (IGE) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||