Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CRUISE CONTROL SYSTEM

DTC    P0571    Brake Switch "A" Circuit

for Preparation Click here


DESCRIPTION

When the brake pedal is depressed, the stop light switch sends a signal to the ECM. When the ECM receives this signal, it cancels the cruise control. The fail-safe function operates to enable normal driving even if there is a malfunction in the stop light signal circuit. The cancellation condition occurs when voltage is applied to terminal STP. When the brake is applied, voltage is normally applied to terminal STP of the ECM through the STOP fuse and the stop light switch, and the ECM turns the cruise control off.

DTC No.
DTC Detection Condition
Trouble Area
P0571
Voltage of STP terminal and that of ST1- terminal of ECM are less than 1 V for 0.5 sec. or more.
  1. Stop light switch
  2. Stop light switch circuit
  3. ECM

WIRING DIAGRAM


E152499E01


E152500E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (STOP LIGHT SWITCH - BATTERY)


    E144327E02
  1. Disconnect the A19 connector from the stop light switch.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    A19-2 - Body ground
    Always
    11 to 14 V
    A19-3 - Body ground
    Ignition switch on (IG)
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT STOP LIGHT SWITCH


    E144510E01
  1. Remove the stop light switch (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Switch pin not pushed
    Below 1 Ω
    3 - 4
    Switch pin not pushed
    10 kΩ or higher
    1 - 2
    Switch pin pushed
    10 kΩ or higher
    3 - 4
    Switch pin pushed
    Below 1 Ω

  1. Install the stop light switch (Click here).



NG
REPLACE STOP LIGHT SWITCH (Click here)
OK


3.CHECK ECM


    E151264E01
  1. Disconnect the D35 connector from the ECM.

  1. Turn the ignition switch on (IG).

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    D35-15 (STP) - Body ground
    Brake pedal is depressed
    11 to 14 V
    D35-15 (STP) - Body ground
    Brake pedal is released
    Below 1 V
    D35-16 (ST1-) - Body ground
    Brake pedal is depressed
    Below 1 V
    D35-16 (ST1-) - Body ground
    Brake pedal is released
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (STOP LIGHT SWITCH - ECM)
OK

REPLACE ECM (for 2GR-FE) (Click here)